Digital Monitoring Products 1912XR Guide de l'utilisateur télécharger pdf (Page 16)

User Menu

Security Command User Menu

Many of the features of your system have been put into a User Menu

you can access from any Security Command keypad. The menu

requires you to enter your security code and then only shows those

functions to which you have access.

To access the User Menu:

1. Press the COMMAND key until MENU? NO YES displays.

2. Select YES. The keypad displays ENTER CODE: –. Enter your

security code and press COMMAND. You can now scroll down

through the list of system features available to your authority level.

The following pages detail each user menu item and provide

instructions on when and how to use them properly. The User Code

Level reflects the

minimum

authority level required.

Alarm Silence

User Code Level: 3 and above.

Function: Silences the alarm bell or siren during an alarm.

Alarm Silence allows you to turn off the alarm bell or siren connected

to your system during an alarm. Using Alarm Silence does NOT stop

an alarm report from being sent to the central station and does not

reset any alarmed devices. Use the Sensor Reset function to reset

devices such as smoke detectors that have latched in alarm.

Note: You can also silence an alarm by entering your security code

and pressing COMMAND while the bell or siren is still sounding.

Using the Alarm Silence Function

1. Access the User Menu.

2. The keypad displays ALARM SILENCE?.

3. Press any SELECT key. The system silences the bell or siren

and returns the keypad to the status display.

Sensor Reset

User Code Level: 1 and 2 - During schedules only. 3 to 9 - Anytime.

Function: Resets smoke or glassbreak detectors. Also clears Fire/

Supervisory alarm and trouble displays.

Sensor Reset is used to reset smoke and glassbreak detectors after

they have been tripped. Once these detectors have tripped, they

must be reset before they can detect any additional alarm conditions.

When Sensor Reset is selected, power to the detectors is temporarily

removed by the system allowing them to reset.

Make sure all smoke is cleared from around the area of the smoke

detectors before performing a Sensor Reset to prevent the alarm

from occurring again.

Resetting the Sensors

1. Access the User Menu.

2. Press the COMMAND key until SENSOR RESET? is displayed.

3. Press any SELECT key. The keypad displays SENSORS OFF

for five seconds followed by SENSORS ON.

4. The keypad returns to the status display.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products 1912XR Guide de l'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products 1912XR