Digital Monitoring Products Canadain XR500 Guide de l'utilisateur télécharger pdf (Page 44)

System Link User’s Guide

•

Modem

: Select this option if you are using a computer modem to dial a DMP 462FM

9600 Baud Modem Card installed on the panel or to the 2400 baud programming

dialer of an XR500 Series or XR100 Series panel.

Note: You must first configure your modem in System Link Configuration before

setting the Modem settings in the Panel Information window. See Modem Tab on

page

15 for information on configuring your computer’s modem.

•

Modem Special

: for XR500 Series (Version 112 or higher) and XR100 Series panel

communication requirements, when a slower baud rate that does not fluctuate is

needed to ensure data integrity. Modem Special allows this type of control when

using a computer modem to dial out.

Note: Only one modem can be used. Select the correct one for your operation.

Remote Key

: (Only operators with Administrator Authority can view the Remote Key.)

Enter a numerical code up to eight digits long that the panel should use as a password to

verify its identity to the System Link computer. The panel must give the correct key to

System Link before any programming may take place. All panels are shipped from the

factory with the key preset as blank.

Note: The programming options listed below vary according to what type of connection you

select in the Type field discussed above.

Phone

: Enter the phone number to dial to access the modem on the panel. This field

appears when you select SCS-1

/ SCS-105 or Modem in the Type field.

Note: If you need to dial a number to access an outside line, enter that number before the

panel's phone number. Also, enter a P for a pause after dialing the number to access the

outside line. For example, if you need to dial 9 to get an outside line, enter 9P then the

panel's phone number.

Note: Modems from some manufacturers require a comma (,) for a pause rather than the

letter P. Check your Modem documentation before entering the panel phone number.

Cfg Button:

Click the Cfg (Configure) button beside the Phone field to open a dialog box

that allows you to configure the 462FM. A pop-up window allows you to configure the

462FM. This button appears when you select Modem in the Type field.

Ring Count

: Enter the number of times the site phone rings before the 462FM

picks up. Enter a number between 1 and 15. The default is 1 ring. You must

increase the Dial Time Out in the Modem Tab about 10 seconds per ring.

Set Modem:

Click this button to dial the phone number programmed in Panel

Information. When the 462FM picks up, the Ring Count is stored in the 462FM

Module's programming. After the 462FM has stored the number, the 462FM

disconnects from System Link. A pop-up window appears stating, “Ring Count

successfully sent.”

Dial

: Select how you want the receiver to handle the phone line connection with the

panel. This field appears when you select SCS-1

/ SCS-105 or Modem in the Type field.

•

: Do not dial the panel phone number to make contact with the panel. This is

used mainly for multiplex and asynchronous accounts.

•

Yes

: Use the panel phone number entered in the Account Information file to dial

the subscriber's panel.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products Canadain XR500 Guide de l'utilisateur Page 44

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products Canadain XR500