Digital Monitoring Products Graphic Touchscreen Guide de l'utilisateur télécharger pdf (Page 36)

32 XT30/XT50 User Guide User Menu

Using the Zone Monitor Function

1. Access the User Menu.

2. Press the COMMAND key until ZONE MONITOR? displays.

3. Press any Select key.

The keypad displays PERIM ALL NBR.

4. Select PERIM to place all disarmed perimeter zones into Zone

Monitor.

4a. The keypad dis`plays PERIM? ADD RMV.

4b. Select ADD to add all perimeter zones to Zone Monitor.

4c. Select RMV to remove all perimeter zones.

5. Select ALL to place all disarmed zones into Zone Monitor.

5a. The keypad displays ALL? ADD RMV.

5b. Select ADD to add all disarmed zones to Zone Monitor.

5c. Select RMV to remove all disarmed zones.

6. Select NBR toenteraspeciczonenumberforzonemonitor.

7. If NBR is selected, the keypad displays ZONE : - ADD RMV.

7a. Enter any zone number and select ADD to add this zone.

7b. Enter any zone number and select RMV to remove the zone.

8. The zone number automatically disappears and a new zone

number can then be entered. See step 7.

System Test

User Code Level: Master, Standard, or Limited.

Function: System Test is used to test the battery, alarm bell or

siren, and central station communi cation. The System Test function

begins automatically as soon as you select it.

Using the System Test Function

1. Access the User Menu.

2. Press the COMMAND key until SYSTEM TEST? displays.

3. Press any Select key. The system test begins automatically

and the keypad displays:

1) BELL SOUNDING during a two second bell test, then:

2) KEYPAD SOUNDING during a two second keypad test, then:

3) BATTERY - OKAY or BATTERY - TRBL to indicate the

battery condition, then:

4) TRANSMIT TEST * and ATTEMPT NO : 1 during the

transmit test, then:

5) TRANSMIT OKAY or TRANSMIT FAILED to show the transmit

test results, then:

6) TEST END to indicate the System Test is complete.

7) Press the Back Arrow key to end the system test.

* The transmit test does not occur on local systems.

Testing your system burglary protection: The System Test function

should be part of your weekly testing and should be followed by

placing the interior and perimeter burglary devices in Zone Monitor

mode. This allows you to open and then close each protected door

andwindowwhilelisteningforthekeypadtobeepconrmingits

operation. See Zone Monitor.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 66 67

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products Graphic Touchscreen Guide de l'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products Graphic Touchscreen