Digital Monitoring Products 1912XR Guide d'installation télécharger pdf (Page 15)

1912XR Installation Guide

Digital Monitoring Products, Inc. 1912XR Installation Guide

Page 15

Reset Jumper J16

16.1 Description

The reset jumper is located just above the terminal strip in the center of the circuit board and is used to

reset the microprocessor of the 1912XR. To reset the panel when first installing the system, install the reset

jumper before applying power to the panel. After connecting the AC and battery, remove the reset jumper.

To reset the panel while the system is operational (for example, prior to reprogramming), install the reset

jumper without powering down the system. Remove the reset jumper after two seconds.

After resetting the panel for programming, you must begin within 30 minutes. If you wait longer than 30

minutes, you'll have to reset the panel again.

16.2 Tamper connector J4

Jumper J4 is used for connecting the DMP 306 tamper kit when required for multiplex or Grade A

operation.

Figure 9: 1912XR panel showing reset

AC BELL

34 56789

14 15

17 18 19

GND

RED YEL GRN BLKB + B - SMK L5+ L5- L1 L2 L3 L4GNDGND

1k Ω

3.3k Ω Resistor

DMP Model 309

1k Ω

Battery Only Restart

J16

Command Processor Reset

1k Ω

Cold Water Pipe

Earth Ground

Place the reset jumper over

both J16 pins for two seconds

to reset the panel.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

Digital Monitoring Products 1912XR Guide d'installation Page 15