Digital Monitoring Products XR350 Guide d'installation télécharger pdf (Page 2)

Digital Monitoring Products 1184 Detector Installation Guide

Selecting the Proper Location

(LED Survey Operation)

For optimum wireless performance, install the transmitter away from large metal objects. Mounting the transmitter

on or near metal surfaces impairs performance. For the LED Survey Operation complete the following steps before

proceeding:

1. Since the 1184 transmitter PCB is not visible, use a separate 1100 Series Transmitter for the LED Survey

Operation such as an 1107.

2. The survey button is located on the 1107 transmitter PCB and the survey LED can be seen near the survey button

location. The transmitter PCB Red Survey LED turns on whenever data is sent to the receiver then immediately

turns off when the receiver acknowledgement is received. Pressing the tamper switch is a convenient way

to send data to the receiver to conrm operation. When the tamper switch is pressed or released, the LED

blinks once to indicate proper operation. When the transmitter does not receive an acknowledgement from

the receiver the LED remains on for about 8 seconds to let you know communication is not established.

Communication is also faulty when the LED blinks multiple times in quick succession. Relocate the transmitter or

receiver until the LED immediately turns off indicating the transmitter and receiver are communicating properly.

3. Also, you can test the communication between the control panel and the detector using the panel walk test

feature. See Testing the Detector Alarm.

General Location Guidelines

In addition to NFPA 720, use the following location guidelines to optimize performance from the CO detector:

•

Locate ceiling-mounted detectors at least 12 inches from any wall

• Locate wall-mounted detectors at least as high as the light switch and at least 6 inches from the ceiling.

• Mount the detector on a rm permanent surface

•

Locate the detector in environmentally controlled areas where the temperature does not exceed 104° F (40° C)

or drop below 32° F (0° C).

• When mounting to suspended ceiling tile, the tile must be secured with the appropriate fastener to prevent

tile removal

• Locate in the vicinity of ame-

fueled appliances, but no closer

than 10 feet.

• Keep detectors away from vents and

the reach of children and pets.

Installing the Detector

Note: When setting up a wireless system,

it is recommended to program zones and

connect the wireless receiver before

installing batteries in the transmitters.

Install the Mounting Base

1. Using the two screws provided,

mount the base in the location

previously surveyed for proper

communication.

Attaching and Removing the Detector

1. Using the alignment notch on

the lip of the mounting base as a

guide, align the detector with the

alignment tabs.

2. Insert the detector into the

mounting base and turn clockwise approximately 15 degrees to snap into place.

To remove the detector from the mounting base, grasp the detector and turn it counterclockwise approximately 15

degrees. The detector snaps off of the mounting base. See Figure 2.

Figure 2: Exploded View of CO Detector

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products XR350 Guide d'installation Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products XR350