Digital Monitoring Products Graphic Touchscreen Guide de l'utilisateur télécharger pdf (Page 50)

XR150/XR350/XR550 User’s Guide 43System Setup

Display Events

Allows you to review up to 12,000 past door access and system

events. There are six event types:

Zone Activity - Zone alarms, troubles, and restorals.

Opening and Closing - System arming and disarming.

User Code - Adding, deleting, and changing user codes.

Schedule Changes - Adding, deleting, and changing schedules.

Door Access - Each door access function used at a keypad.

Supervisory - Problems with system hardware components.

The system memory holds a maximum of 12,000 past events for 45

days. Any event older than 45 days automatically clears from the

system memory. Also, once the full 12,000 events are stored, any

new event causes the oldest event to be cleared. See Appendix A

for Display Events.

Service Request

Your user code prole may be programmed for Service Request.

This User Menu feature allows you to simply press any Select

key when SERVICE REQUEST? displays and have the system

automaticallysenda“RequestforService”messagetothecentral

station. The display changes momentarily to REQUEST MADE to

conrmyourrequestwassent.

Fire Drill

FireDrillisusedtotesttherebellsorrehornsinyoursystem.

The Fire Drill test turns your system bell circuit on, but does not

send a message to the central station.

Starting a Fire Drill test

1. Access the User Menu.

2. PressCOMMANDuntilFIREDRILL?displays.PressanySelect

key.

3. ThekeypaddisplaysSURE?YESNO.

4. Select YES to start the Fire Drill test.

Ending a Fire Drill test

1. EnteryourcodeatthekeypadandpressCOMMANDtoend

the Fire Drill.

2. The Fire Drill test automatically ends with ALARM SILENCE

or the programmed Bell Cutoff time.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 83 84

Pas de commentaire

Digital Monitoring Products Graphic Touchscreen Guide de l'utilisateur Page 50