Digital Monitoring Products XR20 Guide d'installation télécharger pdf (Page 23)

XRSuper6/XR20/XR40 Programming Guide

2500 N. Partnership Boulevard Springfield, MO 65803 www.dmpnet.com Digital Monitoring Products

7.5 OUTPUT ACTION

This option allows you to define the operation of the four on-board annunciator

outputs.

7.5A CUTOFF OUTPUTS

Any or all of the available outputs can be programmed here to turn off after the time

specified in OUTPUT CUTOFF TIME. See section OUTPUT CUTOFF TIME. To disable

this option, press any Select key to clear the display of output numbers and then

press COMMAND.

7.5B OUTPUT CUTOFF TIME

If a Cutoff Output is assigned, you can enter a Cutoff Time of up to 15 minutes for

the output to remain on. If the output is turned off manually, the cutoff time is

reset. The Cutoff Time can be from 1 to 15 minutes. Enter zero to provide

continuous output.

The Cutoff Timer is shared by all outputs. If a second output trips, the timer is not

reset. Both outputs turn off when the original time expires.

7.5C COMMUNICATION FAILURE OUTPUT

This output is turned on when the panel fails to communicate with the receiver after

three successive dial attempts. Enter zero to disable this output.

7.5D FIRE ALARM OUTPUT

This output is turned on any time a fire type zone is placed in alarm. The output is

turned off using the Sensor Reset option while no additional fire type zones are in

alarm. Enter zero to disable this output.

7.5E FIRE TROUBLE OUTPUT

This output is turned on any time a fire type zone is placed in trouble or when a

supervisory type zone is placed in alarm or trouble. The output is turned off when

all fire and supervisory type zones are restored to normal. Enter zero to disable.

7.5F AMBUSH OUTPUT

This output is turned on any time an Ambush code is entered at a keypad. The

output is turned off using the Sensor Reset option. Enter zero to disable this output.

7.5G ENTRY OUTPUT

This output is turned on at the start of the entry delay time. The output is turned

off when the area is disarmed or the entry delay time expires. Enter zero to disable.

7.5H EXIT OUTPUT

This output is turned on any time an exit delay time starts. The output is turned off

when the system arms or when the arming has been stopped. Enter zero to disable.

7.5I READY OUTPUT

This output is turned on whenever all disarmed zones are in a normal state. The

output is turned off when any disarmed zone is in a bad state. Enter zero to disable.

7.5J ARMED OUTPUT

This output is turned on any time an area of the system is armed. The output is

turned off when the system is completely disarmed. Enter zero to disable this

output.

7.5K BURGLARY OUTPUT

This output is turned on any time a burglary zone is placed in alarm. The output is

turned off when the area in which the alarm occurred is disarmed and no other

burglary zones are in alarm. Enter zero to disable this output.

OUTPUT OPTIONS

CO OUTS: - - - -

OUTPUT ACTION . . .

CUTOFF TIME: 0

COM FAIL OUT: 0

FIRE ALR OUT: 0

FIRE TRB OUT: 0

AMBUSH OUT: 0

ENTRY OUT: 0

EXIT OUT: 0

READY OUT: 0

ARMED OUT: 0

BURGLARY OUT: 0

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products XR20 Guide d'installation Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products XR20