Digital Monitoring Products XR20 Guide d'installation télécharger pdf (Page 24)

XRSuper6/XR20/XR40 Programming Guide

Digital Monitoring Products www.dmpnet.com 2500 N. Partnership Boulevard Springfield, MO 65803

7.5L GROUND START OUTPUT

This output is turned on for 750ms any time the panel seizes the telephone line.

Enter zero to disable this output.

7.6 CELLULAR BACKUP OUTPUT

When connected to a double pole, double throw relay, this output allows cellular

communication with the Cell-Miser

restrictions listed below. The panel's telephone

connection, the incoming telephone line, and the cellular telephone should be

connected to the relay to allow the panel's telephone connection to be switched

between the incoming telephone and cellular. Enter zero to disable this output.

1. Only zone alarms, Ambush, or Abort messages are sent over the cellular system.

Delayed Events are sent if the cellular call was made because of an alarm,

ambush or abort.

2. The second phone number is only used when the output is ON and should contain

numbers for a cellular call. This allows the panel to use the cellular phone

number for cellular calls only without needing prefixes or area codes for land line

dialing.

3. The first phone number is always used when this output is off.

4. When a message is sent that is not a Cell-Miser message, such as O/C and

troubles, the output does not turn ON and only the first telephone number is used

for all ten attempts.

Note: When an output is chosen for Cellular Backup, the Backup Reporting option

in Receiver 1 and 2 programming will automatically be set to NO.

7.7 LATE TO CLOSE OUTPUT (XR20/XR40 Only)

Enter the output number to turn on at the expiration of a closing schedule when all

areas are not armed. The output activates simultaneously with the CLOSING TIME!

keypad display. The output is turned off when all areas are armed, the closing is

extended, or the schedule is changed.

LATE CLS OUT: 0

OUTPUT OPTIONS

ATTEMPT CELL BACKUP OUTPUT PHONE NUMBER

1 OFF FIRST

2 OFF FIRST

3 ON SECOND

4 ON SECOND

5 OFF FIRST

6 OFF FIRST

7 ON SECOND

8 ON SECOND

9 OFF FIRST

10 OFF FIRST

GND STRT OUT: 0

CELL BKP OUT: 0

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products XR20 Guide d'installation Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products XR20