Digital Monitoring Products Canadian XR100 Manuel d'instructions télécharger pdf (Page 10)

Digital Monitoring Products XR100 Series Programming Guide

IntroductIon

1.3 Programmer Operation

Thereare18programmingsectionstochoosefrom:

Programming Item Section in This Manual Programming Item Section in This Manual

Initialization 2 Output Information 12

Communication 3 Output Groups 13

Network Options 4 Menu Display 14

Messaging Setup 5 Status List 15

Device Setup 6 PC Log Reports 16

Remote Options 7 Area Information 17

System Reports 8 Zone Information 18

System Options 9

Stop

Bell Options 10 Set Lockout Code 20

Output Options 11

To choose a section for programming, press any top row Select key when the keypad displays the name of

thatsection.Sections2through19containdetailedinstructionsforeachprogrammingstep.

1.4 Programmer Lockout Codes

The panel allows you to enter the programming function without entering a lockout code using steps 1 to 4

listedinGettingStarted.Werecommend,however,thatyouinstallaLockoutCodetorestrictprogramming

to only those persons your company authorizes. You can do this by using the SET LOCKOUT CODE feature in

theProgrammer.TheLockoutCoderestrictsanyunauthorizedpanelprogramming.

Afterresettingthepanelandenteringthecode6653,thekeypaddisplaysPROGRAMMER. Press COMMAND

to advance through the programming sections until SET LOCKOUT CODE displays(afterSTOP).Pressany

top row Select key. The keypad displays ENTER CODE: –.Entera3to5digitProgrammerLockoutCode

and press COMMAND. The keypad displays ENTER AGAIN followed by ENTER CODE: –.Enterthesame3to5

digit code a second time and press COMMAND. The keypad displays CODE CHANGED.

Note:Thepanelwillnotaccepta5-digitLockoutCodehigherthan65535.

Before accessing programmer functions enter the new code number.

WritetheLockoutCodenumberdownandkeepitinasecureplacewithaccesslimitedtoauthorized

personsonly.LostLockoutCodesrequirethepaneltobesentbacktoDMPforrepair.Youmaycancela

LockoutCodebyentering00000attheSetLockoutCodecommand.

1.5 Reset Timeout

ThepanelhasafeaturethatrequiresyoutoentertheProgrammerwithin30minutesofresettingthe

panel.After30minutes,ifyouattempttoprogrambyenteringthe6653(PROG)code,thekeypaddisplays:

RESET PANEL. You must reset the panel and enter the program code then begin programming within the

next30minutes.

IfyouarealreadyintheProgrammeranddonotpressanykeysontheprogrammingkeypadfor30minutes,

the panel terminates programming. All data entered up to that time is Not saved unless you run the Stop

routine.

Note: Use the Stop routine to exit panel Programming. Ensure the keypad displays “SAVING PROGRAM”

to save all programming changes entered.

1.6 Power Up

When the XR100 Series panel is powered up after an AC power failure, any zone transitions are not

recognizedfor60seconds.Normalzoneprocessingresumesattheendofthe60seconds.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products Canadian XR100 Manuel d'instructions Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products Canadian XR100