Digital Monitoring Products Canadian XR100 Manuel d'instructions télécharger pdf (Page 70)

Digital Monitoring Products XR100 Series Programming Guide

Appendix

With each zone trip during the Walk Test:

• Keypaddisplayincrementseachtimeaselectedzoneisopenedorshorted

• Thekeypadbuzzesfortwoseconds

• ThepanelsoundsthealarmbellsasprogrammedinBellAction

• EachtimeaFI,FV,orSVzonetrips,aSensorResetoccurs.

If ENHANCED ZONE TESTisselectedasYES:

AVerifymessageissentatthetimethezonetripoccursinsteadofattheendof

theWalkTest.ForFI,FVorSVzonetypes,theVerifymessageissentattheinitial

trip.Forallotherzonetypes,theVerifymessageissentwhenthezonerestores.

This allows the Central Station to count the number of devices per zone.

END - SelectENDtostoptheWalkTest.WhentheWalkTestendsora20-minute

time-outexpires,analSensorResetoccurs.TheSystemTestEndmessageis

senttothereceiveralongwithVerifyandFailmessagesforeachzoneundertest.

Faulted zones then display on the keypad.

CKIN:XXX/ZZZ END

Trip Counter For DMP Wireless Check-in Test (WLS)

Displays the number of wireless zones that automatically communicate a

supervisioncheck-inmessage.

• Thenumberofzonesthatcheckin.(XXXintheexample).

• Thetotalnumberofwirelesszonesprogrammedforsupervisionthatshould

checkin.(ZZZintheexample).

END -SelectENDtostoptheWirelessCheck-inTest.Whenthetestendsor

a20-minutetime-outexpires,normalwirelesszoneprocessingreturns.If

alltransmitterscheck-in,bothnumbersmatchwithinthree(3)minutes.Ifa

transmitterhasmultiplezones(1101,1114,etc.),allzonesareincludedinthe

counts. Failed wireless zones display on the keypad.

TEST END WARNING

Test End Warning

Whenveminutesremainonthe20minuteWalkTesttimer,thekeypaddisplays

TESTENDWARNING.Ifnoadditionaltestzonetripsoccur,thetestendsanda

nalSensorResetautomaticallyoccurs.TheSystemTestEndmessageissentto

thereceiveralongwithVerifyandFailmessagesforeachzoneundertest.Faulted

zones then display on the keypad.

Note: Key fobs do not send failure messages in order to prevent functioning key

fobsthatarenotpresentatthetimeofthetestfrombeingreportedasMISSING.

SOUTH LOBBY

Failed Zones Display

ZONE: 10 -FAIL

Foreachzonethatdidnottrip(failed)atleastonceduringtheWalkTest,all

keypads with matching Area Display programming display the zone name and

numberandbuzzforonesecond.Anyselected(*FI*PN*SV)24-hourzonethat

is faulted at the end of the Walk Test displays a trouble condition for that zone

regardless of the message programmed for the open or short condition of the zone

and a zone trouble is sent to the receiver. Press the COMMAND key to display the

next failed zone.

Note:FortheWirelessCheck-inTest,failedwirelesszonesdisplayonlyonthe

keypad.ZoneVerify/Failreportsarenotsenttothecentralstationreceiverforthe

wirelesscheck-intest.

21.5 Keypad Speaker Operation

WhenusingLCDKeypads,thepanelprovidesdistinctspeakertonesfromthekeypadforFire,Burglary,

ZoneMonitor,andPrewarnevents.Thelistbelowdetailstheconditionsunderwhichthespeakeristurned

on and off for each event.

Fire On-FirezonealarmandBellOutputorFireBellOutputisON.

Off -AlarmSilence.

Burglary On -BurglaryzonealarmandBellOutputorBurglaryBellOutputisON.

Off-AlarmSilence.

Zone Monitor On-Onetimeonlywhenamonitoredzoneistripped.

Off-Afteronetone.

Prewarn On-DuringEntryDelay.

Off-WhenEntryDelayexpires.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76 77 78

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products Canadian XR100 Manuel d'instructions Page 70

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products Canadian XR100