Digital Monitoring Products XR20 Guide d'installation télécharger pdf (Page 18)

Digital Monitoring Products XRSuper6/XR20/XR40 Programming Guide

CommuniCaTion

3.18

RECEIVER 2 PROG

Receiver 2 Programming

Repeat the instructions for Receiver 1 programming when communicating to a

second receiver. Receiver 2 defaults are set to NO.

If you select YES for any of the Receiver 2 options, you must have at least one

phone number programmed in Receiver 2 programming.

3.19

PAGER? NONE

Pager Type

This option allows the panel to send Alarm, Trouble, Opening and Closing, and Late

to Close reports to a customer’s alphanumeric or numeric pager (numeric only with

XRSuper6). The panel uses DTMF or modem tones to generate the account and

report information sent over the pager terminal equipment.

NONE NUM ALPHA

Selecting NONE allows you to use the Receiver 2 programming to send panel reports

to a second central station receiver.

NONE NUM

(XRSuper6 Only)

NONE - The pager reporting option is not being used.

NUMERIC - Reports are sent to the customer’s numeric pager.

ALPHANUMERIC - Reports are sent to the customer’s alphanumeric pager.

Caution: The XR20/XR40 communicates in a half-duplex mode with a Glenayre

alphanumeric pager terminal. The terminal modem must accept the following

parameters:

• 300 bps Bell 103 protocol

• Carrier detect response time = 300ms

• Delay between lost carrier and hang-up = 12.0 seconds

Instructions for using Pager Direct™ paging and cutout quick reference cards are

included in the XRSuper6, XR20 and XR40 User’s Guides.

3.20

ALARM NO YES

Alarm Reports

YES enables Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Alarm Cancelled,

Ambush, Exit Error, and System Recently Armed reports to be sent to this receiver.

3.21

SPV/TRBL NO YES

Supervisory/Trouble Reports

YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, and Fault reports

to be sent to this receiver.

3.22

O/C USER NO YES

Opening/Closing and User Reports

YES enables Opening/Closing, Door Access, Schedule and Code Changes, and Bypass

reports by user to be sent to this receiver.

3.23

TEST RPT NO YES

Test Report

Enter YES to enable the Recall Test report to be sent to this receiver. Reports are

sent according to the programming in TEST FREQUENCY and TEST TIME.

3.24

BACKUP NO YES

Backup Reporting

YES enables this receiver to be a backup to the other receiver in the event the

other receiver cannot be contacted.

3.25

FIRST PHONE NO.

First Telephone Number

This is the rst number the panel dials when sending reports to this receiver. A

phone number can consist of two lines of 16 characters in length to equal 32

characters. You can program a three second pause in the dial ing se quence by

en tering the let ter P. You can program a dial tone detect by entering the letter D.

Place the “* 7 0 P” (Star, Seven, Zero, Pause) in the telephone number rst position

to cancel Call Waiting. These characters are counted as part of the 32 allowable

characters.

Caution: A call waiting cancel programmed on a non-call waiting telephone

line would prevent communication to the central station.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products XR20 Guide d'installation Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products XR20