Digital Monitoring Products XR20 Guide d'installation télécharger pdf (Page 43)

XRSuper6/XR20/XR40 Programming Guide Digital Monitoring Products

Stop

12.1

STOP

Stop

At the STOP prompt, pressing any Select key allows you to exit the programmer

function of the XRSuper6/XR20/XR40 panel. When selected, the panel performs an

internal reset and exits the programmer. The Stop function causes the following

conditions to occur:

• The system is DISARMED

• All 1100 Series DMP Wireless transmitters are reset to NORMAL

• The panel’s Status List is CLEARED

During the Stop function, all keypad displays are momentarily blank for two

seconds. Afterwards, the programming function is terminated and the keypads

return to the Status List display.

Power Up

When the SIA CP-01 option in System Options is set to Yes, for 60 seconds after

power up or after resetting the panel, any zone transitions are not recognized.

Normal zone processing resumes at the end of the 60 seconds.

SeT loCkouT Code

Set Lockout Code

13.1

SET LOCKOUT CODE

Set Lockout Code

Pressing COMMAND at the Stop prompt displays SET LOCKOUT CODE. This feature

allows you to program a special code that will then be required to gain access to

the panel’s internal Programmer through the keypad.

Changing the Lockout Code

You can change this code at any time to any combination of numbers from 1 to 5

digits long (1 to 65535). Do not use leading zeros for the lockout code.

1. Press any Select key. The display changes to ENTER CODE: -.

2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press

COMMAND.

3. Enter the new Lockout Code again. Press COMMAND. The keypad display

changes to CODE CHANGED.

Once you have changed the code, it is important that you write it down somewhere

and store it in a safe place. Lost lockout codes require the panel to be sent back

into DMP for repair. You may cancel a Lockout Code by entering 00000 at the Set

Lockout Code command prompt.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

SToP

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Pas de commentaire

Digital Monitoring Products XR20 Guide d'installation Page 43