Digital Monitoring Products XR550 Guide de l'utilisateur télécharger pdf (Page 29)

XR150/XR350/XR550 User Guide 25User Menu

Alarm Silence

Silences the alarm bells or sirens during an alarm.

Alarm Silence allows you to turn off the alarm bells and sirens

connected to your system during an alarm. Using Alarm Silence

does NOT stop an alarm report from being sent to the central

station and does not reset any alarmed devices. Use the Sensor

Reset function to reset devices such as smoke detectors that have

latched in alarm.

Note:Thekeypadtonesilencesassoonastherstusercodedigit

key is pressed. You can silence the alarm by entering your user

code or by presenting your card to a reader during the Status List

display. If using a card, areas assigned to your code are disarmed

and door access occurs.

Using the Alarm Silence Function

1. Access the User Menu.

2. The keypad displays ALARM SILENCE?.

3. Press any Select key to silence the bells and exit the User

Menu.

Sensor Reset

Resets smoke or glassbreak detectors. Also clears Fire/Supervisory

alarm, trouble displays or low battery displays on systems using

wireless sensors.

Sensor Reset is used to reset smoke and glassbreak detectors after

theyhavetripped.Oncethesedetectorstrip,theymustbereset

before they can detect any additional alarm conditions. When you

select Sensor Reset, power to the detectors is temporarily removed

by the system allowing them to reset.

Make sure all smoke is cleared from around the area of the smoke

detectors before performing a Sensor Reset to prevent the alarm

from occurring again.

Sensor (Fire) Reset Shortcut Key

All Systems — Press 2 for 2 seconds, then enter your user code if

required, to reset the system.

Resetting the Sensors

1. Access the User Menu.

2. Press COMMANDuntilSENSORRESET?displays.

3. ThekeypaddisplaysSENSORSOFFfollowedbySENSORSON.

4. The keypad automatically exits the User Menu.

Lockdown

Your system may be programmed at installation for an access

control door to be a Public Door. Enabling Lockdown locks all

Public Doors from the keypad in an emergency situation.

Using Lockdown

1. Access the User Menu.

2. Press COMMANDuntilLOCKDOWN?displays.

3. Press any Select key. The door access relay is activated and

all Public Doors are locked.

4. Press COMMANDtoreturntotheStatusListdisplay.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 87 88

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products XR550 Guide de l'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products XR550