Digital Monitoring Products Canadian XR100 Guide d'installation télécharger pdf (Page 32)

Digital Monitoring Products XR100 Series Installation Guide

COMPLIANCE

XR100 Series Installation Guide Digital Monitoring Products

COMPLIANCE

UL 609 Specications

Police Station Connected and Local Burglar Alarm Units and Systems

26.1 Grade A Mercantile

For Grade A Mercantile and Police Station Connect operation the Model XR100 Series must be mounted in a Grade A

Attack Resistant Housing, (DMP Model 350A).

26.2 Entry Delay

The maximum entry delay used must not be more than 60 seconds when using the Model 350A Grade A housing. See

the XR100 Series Programing Guide (LT-0896).

26.3 Exit Delay

The maximum exit delay used must not be more than 60 seconds. See the XR100 Series Programming Guide

(LT-0896).

26.4 Mercantile Safe and Vault

When the DMP Model 350A housing is used, the XR100 Series provides operation as a mercantile safe and vault alarm.

Bell Supervision and wiring must be in accordance with UL 681. When the XR100 Series is mounted outside the safe

or vault, tamper protection and the Sentrol Model 5402 or Potter EVD listed vibration detectors should be used.

26.5 Grade A Bell

A Grade A local audible signal appliance must be used such as Ademco AB12M bell and bell housing.

UL 294 Specications

Access Control System Units

27.1 Panel Designation

The XR100 Series panels are designated stand alone units.

27.2 Tamper Protection

For UL Listed Access Control installations, a tamper switch must be used.

27.3 Compatible Devices

The following devices are compatible with the XR100 Series panels.

Access Control

733 Wiegand Interface Module Proximity reader connector

734 Wiegand Interface Module Proximity reader connector

OP-08CB Motion Detector Infrared sensor

* PB-2 REX Button Exit control push button

PP-6005B Proxpoint Plus® Reader Proximity reader

MP-5365 Miniprox® Reader Slimline proximity reader

PR-5455 ProxPro® II Reader Long range reader with sounder

MX-5375 Maxi-Prox™ Reader Long range reader compatible with 1351 Prox Pass

* This device has not been investigated by UL and shall not be used in UL installations.

Universal UL and NFPA Fire Alarm Specications

28.1 Introduction

The programming and installation specications contained in this section must be completed when installing the

Model XR100 Series in accordance with any of the UL or NFPA re standards. Additional specications may be

required by a particular standard.

28.2 Wiring

All wiring must be in accordance with NEC, ANSI/NFPA 70.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring Products Canadian XR100 Guide d'installation Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Digital Monitoring Products Canadian XR100